Display Control - EAS ELECTRIC EMSS179AX Manual De Usuario

Way to replace the filter
1.The filter installed in this refrigerator is refined by NSF42, which can filter the
smell, chlorine and so on in running water.
2.The replacement cycle of the filter is about 6 mouths. When replacement is
needed, the indicator on the display board will turn on. The replacement cycle
may be shortened according to operating environment.
3.With the function of BY-PASS, it can supply water normally without the filter. If
necessary, additional filter can be installed and used out of the refrigerator by
yourself.
4.During replacement, little water in the connection part may drop out, a
container can be located under it to receive the drops.
5.The filter is installed in the liner of the refrigerator. You can seize the lower
bugle and whirl it leftward to take it out. When it is difficult to take out, you can
detach the lampshade in the refrigerator before detaching the filter.
6.The assembling is in opposite order. Push it upwards and whirl it rightward at
the same time.
Introduction of function
See the following figure for keys and display configuration of man-machine
interface (operation interface is subject to material object).

DISPLAY CONTROL

Power on the display panel to reach full display after 3s, the start-up tone rings
and the panel displays the systemic memory mode and temperature settings.
This is a lock mode.
The factory default memory status of main control board: temperature of
refrigerating chamber and freezing chamber is set to 5ºC and -18ºC
39
V.1