Störungen; Intended Use; Safety Information - Oase InScenio FM Master Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 8
- GB -
Reinigung
Schalten Sie zuerst die Stromversorgung ab, und sichern Sie das Gerät gegen Wiedereinschalten. Reinigen Sie das
Gerät mit einem trockenen weichen Putztuch.
Entsorgung
Das Gerät ist gemäß den nationalen gesetzlichen Bestimmungen zu entsorgen. Fragen Sie Ihren Fachhändler.
Störungen
Störung
Gerät reagiert nicht
- GB -
Information about this operating manual
Please read the operating instructions and familiarise yourself with the unit prior to using it for the first time. Adhere to
the safety information for the correct and safe use of the unit.

Intended use

The series InScenio FM-Master 1, 2, 3, in the following termed unit, is exclusively produced as a power supply distribu-
tor for the corresponding OASE products and has to be used at an outside temperature of between -5°C to +45°C and
with an operating voltage of 220-240 Volt.
Use other than that intended
Danger to persons can emanate from this unit if it is not used in accordance with the intended use and in the case of
misuse. If used for purposes other than that intended, our warranty and operating permit will become null and void.
CE Manufacturer's Declaration
We declare conformity in the sense of the EC directive, EMC directive (89/336/EEC) as well as the low voltage direc-
tive (73/23/EEC). The following harmonised standards apply:
DIN VDE 0620.

Safety information

OASE has manufactured this unit to the current state of the art and the valid safety regulations. Despite of the above,
hazards for persons and assets can emanate from this unit if it is used in an improper manner or not in accordance
with its intended use, or if the safety instructions are ignored.
For safety reasons, children and young persons under 16 years of age as well as persons who cannot recog-
nise possible danger or who are not familiar with these operating instructions, are not permitted to use the
unit!
Please keep these operating instructions in a safe place! Also hand over the operating instructions when passing the
unit on to a new owner. Ensure that all work with this unit is only carried out in accordance with these instructions.
The combination of water and electricity can lead to danger to life and limb, if the unit is incorrectly connected or
misused.
Do not operate the unit in or under water. Never open the unit housing or its attendant components, unless this is
explicitly mentioned in the operating instructions. Compare the electrical values of the power supply with those on the
type plate on the packaging or on the unit itself. For your own safety, consult a qualified electrician if you have ques-
tions or encounter problems! Protect the connection cable when burying to avoid damage. Only use cables approved
for outside use. Protect the plug connection from moisture.
Start-up
Prior to this observe the following operating steps: Place the ground stake (5) and position the unit in the correspond-
ing mounting. Ensure sufficient stability. Connect the unit to the power supply by pushing the power supply bush onto
the unit plug (1). Connect your current consuming units using the LS plug. Note the colour-coded sockets: grey (2) =
permanent, black (3) = switchable, blue (4) = dimmable. We recommend to safely route all cables with a pull-relief (7).
4
Ursache
Handsender sendet nicht
Gerät empfängt nichts
Funkstrecke gestört
Gerät defekt
Abhilfe
Batterie erneuern
Handsender nicht eingestellt
Signature:

Publicidad

Tabla de contenido
loading

Tabla de contenido