EHEIM CO2SET Instrucciones De Uso página 18

C CO SAFE safety hose
2
Connection of the CO
Unscrew the locking nut of the hose connection. Cut the necessary length from the CO
SAFE special hose. Guide the locking nut over the hose. Push the CO
until it hits the hose connection of the pressure regulator and tighten the locking nut again.
Assembly of the CO
Please see all other assembly steps in the respective assembly and operating
instructions of the CO
you are using.
6. Start-up
D1 CO pressure regulator, disposable bottles (Art. No. 6063040)
2
After all components are installed, the CO
of the pressure regulator. Turn direction clockwise.
D2 CO pressure regulator, returnable bottles (Art. No. 6063050)
2
After all components are installed, the CO
pressure regulator. Turn direction counter clockwise.
The CO supply is opened on the adjustment knob of the pressure regulator (turn direction
2
clockwise) until the manometer for the system pressure gauge F displays the necessary
pressure for your CO
E CO fine control valve
2
Open the fine control valve D on the pressure regulator until bubbles rise in the diffuser. It
makes sense to adjust the amount of bubbles to a low amount in the beginning. The amount
can be increased after several hours until the desired CO
SAFE safety hose to the pressure regulator.
2
diffuser
2
system you are using or the respective CO
2
system.
2
supply can be opened on the adjustment knob
2
supply can be opened on the main valve of the
2
content has been achieved.
2
18
SAFE special hose
2
accessory
2
2