Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
0 Degrees Confi guration
mounting surface
Step 3: Align the mounting hardware and begin to fasten the bolts. Use the mount gasket in all mounting
confi gurations to ensure a water-resistant seal and to protect from cosmetic damage. You may also install
an additional mount gasket between the mount plate and mounting surface. Make certain the wires have
been fully extended through the mounting hardware and mounting surface before you fi nish tightening the
bolts.
Step 4: Connect the speaker wires to your amplifi er and LED wires to your +12V and ground sources.
KICKER recommends you solder the connections and secure them with heat shrink.
4
washer
mount base
mount wedge
5/16" stainless steel socket-head cap
screws (use 1/4" Allen wrench)
mount plate
mount gasket
this side facing the mounting
surface in all confi gurations
Publicidad
Tabla de contenido
