HQ-Power VDP150CC6 Manual Del Usuario página 5

e. XLR Pin Layout
f. Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified technician
check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorized persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
Set an address for stand-alone mode using DIP switches 1 to 10. See table below.
a. Stand-Alone Mode
Code Address
0
1
2
3
4
5
6
7
8
9
10
11
VDP150CC6_v2
Address switches
DMX control and stand-alone selection
0
1
2
3
4
5
6
7
8
9
10
11 Mag-DBl-Bl-Gr-Wh-Yell-Red (30 sec)
Effect
White
Blue
Light blue
Rose red
Yellow
Deep orchid
Straw yellow
Green
Red
Light yellow
Magenta
5
Binary No
0000000000
0000000001
0000000010
0000000011
0000000100
0000000101
0000000110
0000000111
0000001000
0000001001
0000001010
0000001011
HQ POWER