THERM PRO TP-60S Manual De Instrucciones página 22

Monitor inalámbrico de humedad y temperatura para interior y exterior
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

inside the remote sensor battery compartment, the
remote sensor temperature/humidity will show on
the base station display which indicates the
EN
synchronization is complete.
5. If you have additional remote sensors, repeat the
above steps to register the remote sensors (up to
3 remote sensors can be registered with one base
station);
6. If you have registered more than one sensor, press
the CHANNEL/SYNC button on the base station to
select the remote channel you want displayed per-
manently on the base station. Press CHANNEL/
SYNC button until you observe a circular arrow on
the base station LCD display under the channel
number. The unit will then auto-scroll, changing
from channel to channel every 5 seconds.
NOTE: If you have additional remote sensors, when you
-42-
are
synchronizing remote sensors with the base station,
the unit will keep changing from channel to channel in
the first three minutes, after that you can select any
channel you like or auto-scroll mode.
Place the Base Station and Remote Sensor
1. The indoor base station (receiver) should always be
placed in a well ventilated indoor area and located
away from vents, heating or cooling elements, direct
sunlight, windows, doors, or any other openings.
2. The remote sensor (transmitter) can be placed on a
flat surface indoor or outdoor. Make sure the sensor
is within the transmission distance from the base
station and with minimal obstructions.
3. The base station and remote sensor can both be
wall mounted.
NOTE: Although the remote sensor is designed to be
-43-
EN

Publicidad

Tabla de contenido
loading

Tabla de contenido