Overlay Door Panel Installation - Marvel MP15CPG2 Serie Instrucciones De Instalación, Operación Y Mantenimiento

NOTE
Canceling clean mode:
To exit clean mode press and hold the "ON/OFF" icon
until "OFF" is displayed. Wait 3 minutes for clean mode to
complete it's cancel routine before turning unit back on by
pressing and holding the "ON/OFF" icon. If you turn the unit
back on before the 3 minutes has elapsed, the display will
show "CLEAN" and the unit will shut itself off upon comple-
tion of the 3 minute clean cancel routine.
WARNING
!
If you cancel clean mode after adding ice maker
cleaner, you must re-start cleaning and allow clean
cycle to complete to remove the cleaning solution
before resuming ice production.
Optional: After the cleaning cycle has been completed ,
you may wash the interior with a mild detergent / dish soap
or a solution of two tablespoons of baking soda and one
quart of water. Rinse with clean water.
Replace the grid cutter cover.
CAUTION
!
Do not use bleach based cleaners or any abrasive cleaning
products. Chlorine based cleaners will attack the stainless
steel, making it susceptible to corrosion.
Your ice machine is now ready to
restart. Press and hold the "ON/OFF"
icon for 3 seconds until "ICE is dis-
played.
NOTE
After cleaning it is recommended you discard the ice pro-
duced after 3 hours of ice production.

OVERLAY DOOR PANEL INSTALLATION

ICE
If you purchased an overlay panel model, your unit is
equipped with articulated hinges to allow fully integrated
built-in installations. Custom panel thicknesses of
mm) and ⁄ " (18 mm) are accommodated.
3
4
CAUTION
!
It is important to use the factory provided grille that came
with the product to assure proper air flow is maintained
through the condenser. The use of a custom grille is not
recommended and will void the warranty.
!
Overlay panel models are designed for use with built-
in installations only. Use in freestanding installations
could result in personal injury.
Step 1: Removing the Door
With a phillips screwdriver remove the screw and "P" clamp
from the bottom of the door near the hinge. See Figure 27b.
Disconnect the door wire harness by pressing and holding
down the locking tab on the wire connector and pulling the
connector apart. See Figure 28.
Open the door and loosen the screws holding the hinges to
the cabinet (2 at the top and 2 at the bottom hinge). Do not
remove the screws but loosen them enough so the hinges
can be slipped off of the screws when sliding the door to
the side.
!
The articulated hinges have many pinch points. Care-
fully close / collapse the hinges as soon as the door is
removed from the cabinet.
With a helper, and being careful not to scratch the cabinet
or the door, slide the door to the side about
remove the hinges and door from the unit.
!
Use extreme caution with the articulated hinges. The
hinge is self closing and many pinch points exist prior
to built-in installation. Do not remove the cabinet "Z"
bracket from the top of the cabinet.
17
5
WARNING
WARNING
⁄ inch and
1
2
WARNING
⁄ " (15
8