Programming; To Add Or Reprogram A Hand-Held Remote Control; To Erase All Codes; 3-Function Remotes - Craftsman 139.53920D Manual Del Propietário

PROGRAMMING
NOTICE: If this Security_ garage door opener is operated with a non-rolling code transmitter, the technical
measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling cede transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control, The door will open and close when you press the large push butlon.
Below are instructions for programming your opener to operate with additional Security+ _ remote controls=
To Add or Reprogram a Hand.held Remote Control
USING THE "LEARN" BUTTON
1 Press and release the "learn"
button on the motor unit The
learn indicator light wilf glow
steadily for 30 seconds,
2 Within 30 seconds, press and
hold the button on the hand-
held remote* that you wish to
operate your garage door,
...] /
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "learn" button on
motor unit until the leam indicator
light goes out (approximately 6 seconds). All previous
codes are now erased Reprogram each remote or
keyless entry you wish to use
*3.Function Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security+ = 3-Function
remote or compact
remote can be
programmed to operate
other Security+ e garage
door openers.
3 Release the button when the
motor unit lights blink. It has
learned the code, If light bulbs
are not installed, two clicks will
be heard,
35