1 BY ONE 471NA-0002 Manual De Instrucciones página 5

USB OPERATION
EN
1. Press the USB-MP3 button to turn on USB mode. The blue indicator light will turn on.
DE 2. Insert the USB device into the USB input on the turntable and the music tracks on
the USB device will start playing.
FR
3. Press the or buttons to choose your desired track.
4. Press the button to pause or play the track.
ES
5. Press the STANDBY/ON button to turn off the turntable when you are done.
JP
NOTE
IT
1. USB-MP3 playing mode has a memory function. When reinserting
the same USB device, the last played track will be resumed.
2. This turntable is equipped with a USB socket that can play MP3/WMA files stored
on standard USB flash drives (compatible with USB version 2.0).
3. USB flash drives with more than 32GB memory may not be compatible.
4. Although this product is fully compatible with the USB 2.0 standard format, a small
percentage of USB flash drives might not be readable due to those device manu-
facturers' non-compliance with full (official) USB standards.
REMOVING THE USB DRIVE
Please be sure the stop playback and turn the unit off before removing the USB
drive to avoid damage to the USB and the turntable.
BLUETOOTH OPERATION
1. Press the BT button on the front left panel to activate the BLUETOOTH function and
the blue LED light will be flashing.
2. Set up the Bluetooth playback device so it searches for other Bluetooth devices.
3. Select the entry '1byone BS008' from the list of found devices on your Bluetooth
playback device. If pairing is successful, the LED light will stop flashing and stay on
Blue.
4. Play your music through the connected device and enjoy.
06
NOTE
1. The next time you turn on the device it will automatically connect to the last
Bluetooth playback device connected. If your Bluetooth playback does not
automatically reconnect to the device, you will need to manually re-establish the
connection to your Bluetooth device.
2. If you use a smartphone as your Bluetooth playback device, the audio file will
muted when there is an incoming call. Acceptance/termination of the call is carried
out via the smartphone. After finishing the call, music playback will resume
automatically.
LINE OUT OPERATION
1. A set of Line Out jacks is included to allow audio from BT, USB-MP3, and
PHONOGRAPH of this turntable to play on an external device.
2. Insert the audio cable (not included) into the turntable's Line Out socket.
3. Operate the turntable as usual.
4. In order to achieve the best sound, it is advised to set the turntable volume to a
minimal level.
5. The turntable's audio will then be played back through the external device.
REPLACING THE STYLUS
It's suggested to replace the stylus after 400 hours of use.
Please follow the steps below to change the stylus:
1. Lift the tone arm off the tone arm lock.
2. At the front end of the tone arm, place the tip of your fingernail between the red
stylus holder and the black cartridge housing as shown. Press down down on the
red stylus holder until it separates from the cartridge housing.
3. Completely remove the red stylus holder with worn stylus and discard it.
4. Place the new red stylus holder with stylus under the cartridge housing. First, press
upward on the back side of the stylus holder, and then press up on the front edge
of the stylus holder until it snaps into place on the cartridge housing.
07
EN
DE
FR
ES
JP
IT