Kreg KMA2685-INT Manual Del Propietário página 4

3
MOUNTING DRAWER-SLIDE CABINET MEMBERS
Under-Mount Drawer Slides
Position the Brackets
• Extend only the Lower Slider on each
bracket.
• Position Bracket A on the left side of the
cabinet, Bracket B on the right side, with
both Brackets extending into the cabinet.
• Position the Brackets with the top surfaces of
the Upper Sliders flush with the top surface
of the face-frame rail that is under the drawer
opening and the Lower Sliders against the
inside faces of the face-frame stiles.
• Clamp the Brackets to the face frame.
Fasten the Drawer-Slide Cabinet Members
• Place the cabinet members of the drawer
slides on the Brackets. For overlay
drawer fronts, follow the drawer-slide
manufacturer's instructions for the slide
setback distance from the face of the stile.
For inset drawer fronts, add the thickness
of the drawer front.
• Using the vertical mounting slots in the
drawer-slide cabinet members as guides,
drill pilot holes and screw the slides in
place.
• Remove the Brackets from the cabinet.
ATTENTION Where the inside edges of the face-frame stiles are flush with the inside faces of the cabinet sides,
do not extend the Lower Sliders. Clamp the Brackets to the cabinet sides. Make sure the clamp pad bears on
the Bracket ribs, not the webbing between the ribs, including the web area with the Kreg logo. Clamping with the
clamp pad on the webbing could crack the Bracket.
FACE-FRAME CABINETS
Lower slider extended