Kreg KMA2685-INT Manual Del Propietário página 9

ATTENTION When installing the drawer members of ¾-extension drawer slides with flanges that extend under
the sides of the drawers, turn the drawer upside down on your workbench and install the drawer members,
observing the manufacturer's setback from the front of the drawer.
• Slide the spacers out of the cabinet until
they protrude 4" [102mm], keeping the
remaining length of the spacers under the
drawer slides mounted inside the cabinet.
• Place the drawer box on the spacers with
the front of the box aligned with the ends
of the spacers.
• Extend the drawer slides. Follow the
drawer-slide manufacturer's instructions
for the slide setback distance from the
front of the drawer box.
• Using the holes in the drawer-slide drawer
members as guides, drill pilot holes for the
front screws and screw the slides to the
drawer box.
• Extend the drawer to expose the middle
mounting holes, drill pilot holes and drive
the screws.
• For ¾-extension drawer slides, remove the
drawer from the cabinet. Using the rear
mounting holes as guides, drill pilot holes
and drive the screws.
• For full-extension drawer slides, extend
the drawer all the way. Using the rear
mounting holes as guides, drill pilot holes
and drive the screws.
• Remove the spacers.
• Check the drawer operation and adjust the
position of the drawer box as necessary by
adjusting the position of the drawer-slide
cabinet members. When satisfied with the
fit, use the round holes in the drawer-slide
cabinet members as guides to drill pilot
holes and drive screws to fix the drawer-
box position.
FRAMELESS CABINETS
Spacers extended 4" (102 mm)
8