Warning Plates; Testing, Delivery, Installation; Testing; Delivery And Handling - Nilfisk CV Serie Manual De Instrucciones

CV 10, CV 15, CV 15W-AV, CV 18, CV 30, CV 30W

Warning plates

WARNING!
Comply with the data plate warnings.
Failure to do this could cause personal injuries
and even death.
Check that the data plates are always affixed and
legible. Replace them if this is not the case.

Testing, delivery, installation

Testing

The machine will have been tested in our plant in order
to ensure that it operates correctly.
Tests on the suction values are carried out during this
phase.
This ensures that the vacuum has been optimized
according to the job for which it was designed.

Delivery and handling

All the dispatched equipment will have been thoroughly
checked before being delivered to the haulage
contractor.
The vacuum can be directly consigned by authorized
personnel with no packing.
In other cases, it is fixed to a pallet or is simply
wrapped in plastic film.
On arrival, check the machine to see that it has not
been damaged during transport.
If this is the case, immediately lodge a complaint with
the haulage contractor.
Use a lift truck to lift and convey the packed vacuum.
WARNING!
Lift the machine with a truck of adequate carrying
capacity.
In view of the particular height of the vacuum,
GB
check that the load is firmly positioned on the
forks.
When conveying the vacuum, keep the load as
low as possible to ensure greater visibility and
stability, and to work in safety.
The forks must be widened and positioned in the
centre of the pack.
Check the weight of the vacuum cleaner before it
is lifted and transported.
C311

Certificate of guarantee

The certificate of guarantee is consigned together with
the vacuum. Fill out the guarantee card and send the
coupon to the Manufacturer within the period indicated
on the guarantee certificate itself.
Failure to do this will void the guarantee.

Installing the vacuum

WARNING!
The user shall be responsible for ensuring that
installation complies with the local provisions in
merit.
The equipment must be installed by qualified
technicians who have read and understood the
instructions herein.
The floor on which the vacuum must operate
should be level, flat and solid.
If the vacuum is to work in a fixed position, allow
ample space all round in order to ensure freedom
of movement and allow the maintenance staff to
operate with ease.

Environmental conditions of use

Unless established differently on order, the vacuum
is designed to operate in the following environmental
conditions:
- maximum altitude 800 m (until 2,000 m with
reduced performances);
- ambient temperature:
minimum: -5°C;
maximum: +40°C.
Lighting
The lighting system in the factory is important for the
safety of the personnel and quality of the work.
The place in which the machine is installed must, with
natural or artificial lighting, guarantee good visibility in
all points of the machine.
It must ensure that the warnings and danger signs
affixed to the machine can be clearly read and that
the control buttons and monitoring indicators can be
identified.
The lighting must not create stroboscopic effects.
6
11/2016