N OTE: Thoroughly clean and remove all debris from the water supply pipe
before beginning your installation. This will prevent clogging in the spray
outlet.
IMPORTANT!
For proper installation, a nipple with a 1/2" NPT male thread extending
between 3/8" and 7/8" beyond the finished wall is required. If this is already
present, proceed to step 3.
NOTE: The hole for the nipple should be not larger than 1" in diameter.
1) Measure from the supply elbow
inside the wall to the finished wall
surface to properly size the nipple.
2) Wrap pipe tape around one end
of the nipple and fasten it to the
supply elbow.
3) Remove the set screw and slide the
pipe adapter out from the spout,
taking care not to damage the
o-ring.
4) Wrap pipe tape around the other
end of the nipple, then thread
the pipe adapter onto the nipple,
taking care not to damage the
o-ring.
5) Slide the spout onto the pipe
adapter, taking care not to damage
the o-ring.
6) Secure the spout with the set
screw.
INSTALLATION PROCEDURE
Illustration 1
1/2" NPT Nipple
Pipe Adapter
5
Finished
Wall
3/8" to 7/8"