Tribest Sedona SDC-S101 Manual De Instrucciones página 10

NOTE:
• The stand-by time is 5 seconds. After you press the SET button, if you do not begin to set
the temperature or timer setting within 5 seconds, the set-up mode will be cancelled.
• For faster and more accurate setting of the temperature and time, the dehydrator has 2
separate buttons of 10 and 1. The buttons under the 10 represent increments of ten,
whereas the buttons under the 1 represent increments of one.
• You may set the dehydrating time up to 99 hours.
• The dehydrator has a Continuous Operation ("Co") dehydration function which allows you to
continuously dehydrate for more than 99 hours. To enable this function, press and hold the
10 Up button until Co is displayed.
• The Co function will dehydrate for a maximum of 120 hours.
• The default setting of the dehydrator is 45°C (113°F) for 10 hours.
• The dehydrator will save your settings for next use even when you turn off the dehydrator.
While the machine is operating, the SET button also turns on two internal LED lights so you
can see inside the machine without opening the door. While the machine is running, press
the SET button, and small LED lights in the top, turn on for up to 10 seconds, creating a
small beeping sound twice. The lights turn off automatically.
4. UP/DOWN buttons (10 and 1) are for setting the temperature or the hours for the timer.
The 10 Up/Down buttons will change the setting by 10 hours or degrees. The 1 Up/Down
buttons will change the setting by 1 hour or degree. Press and hold down the buttons for
continuous scrolling.
5. TEMPERATURE display is used for two separate functions:
• Setting Desired Temperature- During set up this display will be used to set the desired
temperature of the drying compartment.
NOTE: The condition of the inflowing air may adversely affect the actual compartment
temperature. The actual compartment temperature may read a +/- 5°C (9°F) difference.
The difference is registered by the thermal sensor, thus regulating the heating mechanism
activity.
• Temperature Display- Will display your desired temperature setting.
NOTE: While the temperature displayed by the Temperature Display is set to the desired
setting, the actual temperature in the drying chamber may fluctuate up to ±5°C (41°F).
6. TIMER display will show the total number of hours set for each desired temperature.
This timer automatically counts down, showing the time remaining for dehydrating.
7. °F/°C button will enable you to select the temperature display mode (Fahrenheit or Celsius).
NOTE: The default setting of Sedona Supreme is in Celsius (°C). Once you set the machine to
Celsius or Fahrenheit, the Sedona Supreme will remember your setting even after you turn off
the dehydrator.
10