Insert The Batteries - TFA Dostmann PRISMA Instrucciones De Uso

TFA_No_30.3063_Anleitung_01_20
PRISMA
– Wireless thermometer
A 8: Battery symbol for base station
A 9: Symbol for auto-reset of the maximum-minimum values
Buttons
B 1: SET/MAX/MIN button
B 2: +/SEARCH button
Housing
C 1: Mounting hole
C 2: Battery compartment
5.2. Transmitter (Fig. 2)
D 1: LED signal lamp
D 2: TX button
D 3: Battery compartment
D 4: Mounting hole
6. Getting started

6.1 Insert the batteries

• Place the instruments on a table at a distance of about 1.5 meters
from each other. Avoid being close to possible sources of interfer-
ence such as electronic devices and radio equipment.
• Remove the protective film from the base station display.
• Open the battery compartment of the base station and insert two
new AAA 1.5V batteries, polarity as illustrated.
• All segments will be displayed briefly.
• Close the battery compartment again.
• Open the battery compartment of the outdoor transmitter.
• Insert two new AA 1,5 V batteries, polarity as illustrated.
• Close the battery compartment again.
6.2 Reception of outdoor transmitter
• After inserting the batteries into the outdoor transmitter the trans-
mitter will automatically transmit the temperature. The reception
symbol will be flashing on the display.
14
07.01.2020 12:05 Uhr Seite 8
PRISMA
– Wireless thermometer
• If the reception of outdoor temperature fails, "- -" appears on the dis-
play. Check the batteries and try it again. Check if there is any source
of interference.
• You can also start the initialization manually. Press and hold the
+/SEARCH button on the base station for three seconds.
• "- -" appears on the display and the reception symbol flashes on the
display. The base station will scan again the outdoor temperature.
• Press the TX button in the transmitter's battery compartment.
7. Operation
• The device will automatically quit the setting mode if no button is
pressed for 20 seconds.
• Press and hold the +/SEARCH button in setting mode for fast mode.
8. Settings
• Press and hold the SET/MAX/MIN button in normal mode.
• The hour digit flashes on the display.
• Press +/SEARCH button to adjust the hours.
• Confirm the setting with the SET/MAX/MIN button and set minutes in
the same way.
• Confirm the setting with the SET/MAX/MIN button.
• MAX/MIN flashes on the display.
• Press the +/SEARCH button to activate the automatic reset of the
maximum-minimum values (AUTO).
• Confirm the setting with the SET/MAX/MIN button.
• The set time appears on the display.
9. Maximum/Minimum function
• Press the SET/MAX/MIN button in normal mode.
• MIN appears on the display.
• The minimum values measured since the last reset appear on the
display.
• Press the SET/MAX/MIN button again.
• MAX appears on the display.
• The maximum values measured since the last reset appear on the
display.
15