Unpacking, Moving, Use And Storage; Setting To Work - Connection To The Power Supply; Extensions - Nilfisk S2 B Manual De Instrucciones

Unpacking, moving, use and storage

Operate on flat, horizontal surfaces.
The load-bearing capacity of the surface the vacuum cleaner
is placed on must be suitable for bearing its weight).
Setting to work - connection to the power
supply
WARNING!
■ Make sure there is no evident sign of damage to
the vacuum cleaner before starting work.
■ Before plugging the vacuum cleaner into the
electrical mains, make sure the voltage rating
indicated on the data plate corresponds to that of
the electrical mains.
■ Plug the vacuum cleaner into a socket with a
correctly installed ground contact/connection.
■ Make sure that the vacuum cleaner is turned off.
■
The plugs and connectors of the connection
cables must be protected against splashes of
water.
■ Make sure that connections to the electrical
mains and plug are correct.
■
Use the vacuum cleaners only when the cables
that connect to the electrical mains are in perfect
condition (damaged cables could lead to electric
shocks!).
■
Regularly check there are no signs of damage,
excessive wear, cracks or ageing on the electric
cable.
WARNING!
When the vacuum cleaner is operating, do not:
■
Crush, pull, damage or tread on the cable that
connects to the electrical mains.
■ Only disconnect the cable from the electrical
mains by removing the plug (do not pull the
cable).
■
Only replace the electric power cable with one
of the same type as the original: H07 RN - F. The
same rule applies if an extension is used.
■
The cable must be replaced by the manufacturer's
Service Centre staff or by equivalent qualified
personnel.
07/2018

Extensions

If an extension cable is used, make sure it is suitable for the
power input and protection degree of the vacuum cleaner.
Minimum section of extension cables: 2.5 mm
Maximum length = 20 m
Cable = H07 RN - F
WARNING!
Sockets, plugs, connectors and installation of the
extension cable must maintain the IP protection
degree of the vacuum cleaner, as indicated on the data
plate.
WARNING!
Never spray water on the vacuum cleaner: this could
be dangerous for persons exposed and could short
circuit the power supply.
WARNING!
The vacuum cleaner's power socket must be protected
by a differential circuit-breaker with surge current
limitation, that shuts off the power supply when the
current discharged to the ground exceeds 30 mA for
30 msec. or an equivalent protection circuit.
5
S2B/S3B
2
GB
C352