Sony UP-897MD Manual De Instrucciones página 39

Item Function
SHARP To adjust the
sharpness of the
printout
d)
SIDE To select the
direction in which
the image is to be
printed
SPEED To select the
(When printing speed
"ME:HD" is
selected in
"MEDIA,"
the printing
speed is fixed
to "SP:NOR"
and this item
is not
displayed.)
VIDEO To select the
video signal
output from the
VIDEO OUT
connector on the
rear panel
BACK To exit menu
mode
Settings
You can set the sharpness to
any of 15 steps, from 0 to
14.
At a setting of 0, the outline
of the printout is not
emphasized.
A setting of step 2 is the
factory setting.
BACK: Cancels the setting
change and returns to the
item selection column.
S:SIDE: Prints the image
rotated by 90 degrees
counterclockwise.
[S:STD]: Prints the image in
the same direction as that
displayed on the monitor.
BACK: Cancels the setting
change and returns to the
item selection column.
SP:NOR: Prints at the
normal speed.
[SP:HI]: Prints at high
speed.
BACK: Cancels the setting
change and returns to the
item selection column.
Note
When "SP:HI" is selected,
the power consumption is a
little higher, compared with
printing at the normal
speed.
VI:EE: Outputs the signal
after it is processed by the
printer.
[VI:THR]: Outputs the signal
directly without processing.
BACK: Cancels the setting
change and returns to the
item selection column.
Display this item and then
press the jog dial. The unit
exits the menu mode and
"READY" is displayed on
the LCD.
a) The aspect ratio is as follows.
When AS:4:3 is selected
b) The printing direction is as follows.
When DI:NOR is selected
c) The range of the image to be printed is as follows.
When SC:NOR is selected
When SC:WD1 is selected
Adjustments and Settings Using the Menu
When AS:1:1 is selected
When DI: REV is selected
When SC:WD2 is selected
39