Preventing Equipment From Falling Over; Detaching The Plasma Display From The Stand - Pioneer PDK-TS04 Manual De Instrucciones

Preventing Equipment from Falling Over

After installing the stand, be sure to take measures so that the equipment will not fall over.
Stabilizing on the floor
Stabilize the equipment as shown in the diagram using
screws that are available on the market.
Note
To stabilize the equipment on the
floor use screws that have a
nominal diameter of 6 and that are
at least 20 mm (25/32 inch) long.
Angle of rotation: Without speakers
Unit: mm (inch)
* : 43 inch display model
** : 50 inch display model

Detaching the Plasma Display from the Stand

To remove the plasma display from the stand, be sure
to always follow the procedure described below to
prevent accidents
Caution
1
First clear a space on a flat floor etc. where
you can lay the plasma display flat, then
cover the clear space with a sheet or other
material to protect it from scratches or
other damage.
2
Remove the speakers.
18
En
Max. 5 mm
Min. 20 mm
(0.2 inch)
(25/32 inch)
120
575 (22-21/32)*
(4-23/32)
500 (19-11/16)**
Using a wall for stabilization
(43 inch display model in the figure)
1
Attaching falling prevention bolts (hooks)
to the plasma display.
2
Using strong cords or chains to firmly
stabilize it to a wall, pillar, or other sturdy
element.
Perform this work in the same way on the left and
right sides.
The length of the cords or chains used must be long
enough to allow the stand to rotate freely.
Note
Use hooks, ropes, chains, and fittings
that are available on the market.
Recommended hook: Nominal diameter 8
Length 12 to 15 mm (15/32 inch)
1
Hook
2
Cord or chain
Fitting
3
Referring to steps 2 and 3 in Attaching the
Plasma Display (Page 15.), remove the
black screws (4 screws).
Note
At this time, do not remove the silver screws. If you do,
the column supports might slip out of place and fall over.
4
Holding the plasma display by its handles
and from the bottom, lift the display verti-
cally.
5
Place the screen slowly down onto the
cloth laid out in step 1.
12–15mm
(15/32 inch)