OBJ_BUCH-0000000096-002.book Page 12 Tuesday, November 17, 2015 3:57 PM
en
12
en
Original Instructions for Jigsaw.
Symbols, abbreviations and terms used.
Symbol, character
Explanation
Make sure to read the enclosed documents such as the Instruction Manual and the General
Safety Instructions.
Observe the instructions in the text or graphic opposite!
Do not touch the saw blade.
Before commencing this work step, pull the mains plug out of the socket. Otherwise there will
be danger of injury if the power tool should start unintentionally.
Use eye protection during operation.
Use ear protection during operation.
Use protective gloves during operation.
A surface that can be touched may be very hot and thus hazardous.
Additional information.
Gripping surface
Confirms the conformity of the power tool with the directives of the European Community.
This sign indicates a possible dangerous situation that could cause severe or fatal injury.
WARNING
Worn out power tools and other electrotechnical and electrical products should be sorted
separately for environmental-friendly recycling.
Product with double or reinforced insulation
Max. work-piece thickness for steel with up to 400 N/mm
Fe 400
Max. work-piece thickness in steel (INOX)
Fe INOX
Max. work-piece thickness for aluminium with up 250 N/mm
Al 250
Max. work-piece thickness in softwood
Max. work-piece thickness in hardwood and plywood
Max. work-piece thickness in copper/brass
Cu, Ms
Max. work-piece thickness in fibreglass/hard particle materials
GFK
Radius of smallest curve in steel, wood/plastic
r
Low stroke rate
High stroke rate
Character
Unit of measurement,
international
P
W
1
P
W
2
n
/min, min
0
U
V
Hz
f
Unit of measurement,
national
W
W
-1
, rpm, r/min
rpm
V
Hz
2
2
Explanation
Power input
Output
Stroke rate at no-load
Rated voltage
Frequency