Tabla de contenido
Publicidad
3) Completely remove the small
nose screws (A) and the top
nose plate (B) to reveal the
jammed fastener.
4) Using caution not do bend or
damage the driver blade, using
pliers or a screwdriver if required
to clear the jammed fastener.
5) Put the nose plate (B), back
on the nose (C), fastening it with
the screws (A).
6) Reconnect the tool to the air
resource.
7) Reload the tool with fastener.
ASSEMBLY PROCEDURE FOR
SEALS
WARNING: Disconnect the air
supply from the tool before
performing maintenance.
When repairing a tool, the
internal parts must be cleaned
and lubricated. Parker O-lube or
equivalent must be used on all
O-rings. Each O-ring must be
coated with O-lube before
assembling. A small amount of
oil must be used on all moving
surfaces and pivots.
After reassembling, a few drops
of 30W non-detergent oil or
equivalent must be added
through the air line before
testing.
EXPLANATION OF THE
NAILING ACTION
SINGLE SEQUENTIAL MODE
This mode requires the
trigger to be pulled each
time a fastener is driven. The
tool can be actuated by
depressing the WCE against
the work surface followed by
pulling the trigger.
The trigger must be released
to reset the tool before
another fastener can be
driven.
WARNING: Never operate tool
unless WCE is against with
the work piece.
5
Publicidad
Tabla de contenido
