Installation; Installing The Leveling Legs; Installing The Handles - Conglom QL107 Manual Del Usuario

Installation

INSTALLING THE LEVELING LEGS

- Remove the utility sink (D) and place it on a soft, protective
surface (Fig . 1) .
- Gently place the cabinet (A) onto its back on a soft, protective
surface .
A
- Screw the four leveling legs (G) into the pre-installed nuts on
the bottom of the cabinet (Fig . 2) .
- Gently rotate the cabinet (A) right side up .
- Using a carpenter's level, turn the base of each leg until the
cabinet is level .
NOTE:
The caster (H) is pre-installed.
INSTALLING THE HANDLE
- Insert two handle screws (AA) into the pre-drilled holes .
- Attach the handle (C) and tighten the handle screws (AA) .
QL107
WARNING:
Always wear safety goggles and gloves during
installation .
CAUTION:
Do not rest or bump the leveling legs on the side
as this may cause them to detach or break .
D
Fig . 1
G
6
H
Fig . 2
AA
C