Installing The Faucet - Conglom QL107 Manual Del Usuario

Installation (continued)

INSTALLING THE FAUCET

- Remove the retaining nut, metal washer, and rubber gasket
from the mounting shank of the faucet .
- Insert the faucet hose and the mounting shank through the
faucet hole in the sink and rest the faucet on the sink .
- Install the rubber gasket, metal washer, and retaining nut onto
the mounting shank to secure the faucet to the sink . Hand
tighten the retaining nut until it is snug . Tighten the screws of
the retaining nut using a screw driver . Do not overtighten .
- Connect the main water supply outlet to the sprayer hose using
the quick connector as shown . Connect the end of the quick
connector marked with an "S" to the sprayer hose and the
other end to the main water supply hose of the faucet .
Lightly tug on the quick connect fittings to ensure they are
fully engaged .
- Fully retract the sprayer hose . Install the counterweight about 2
in . (50 mm) from the bottom on the side closest to the
sprayer head .
- Attach and hand tighten the supply lines (not supplied) onto
the faucet inlet fittings. Use two wrenches to tighten the two
ends together. Please note, tightening the fittings with a single
wrench may damage the faucet and void the warranty .
NOTE:
It is helpful to have a second person hold the faucet in place while
tightening the mounting nuts. Please ensure that none of the supply lines
are kinked during installation.
Faucet body
Rubber
Gasket
Retaining
Nut
Hot / Cold
Supply Lines
Supply Line
Inlet Fittings
Counterweight
Faucet outlet
Hose
7
Please contact cs@conglomkb.com or 1-877-333-0098 for further assistance .
Spring
Spray Head
Fitting
Spray
Faucet
Head
Mounting
Shank
Metal
Washer
Screws
Main Water
Supply Outlet
Quick
Connector
Water Supply
Fitting
Sprayer Hose
QUICK CONNECTOR
Main Water
Supply Outlet
Quick
Connector
Sprayer Hose
CONGLOMKB .COM