Delta 50-850 Manual De Instrucciones página 10

9. Attach the lower dust bag retaining clip (A) Fig. 13,
to the dust collector drum. Align the two holes (B) in
the retaining clip (A) Fig. 13, with the two holes in the
drum. Insert a 1/4-20 x 5/8" hex head screw through
the holes in the retaining clip and the holes in the
drum. Place a 1/4" flat washer onto the screws, and
thread 1/4-20 hex nuts on the screws and tighten
securely. Repeat this process for the three remaining
sides of the drum.
ASSEMBLINg dUST INTAKE PORT CAPS
disconnect the machine from the
power source!
1. NOTE: Two dust intake port caps (D) Fig. 14, are
supplied with the dust collector. The caps are to be
placed into the dust intake ports (E) when the intake
ports are not in use.
2. Place the collar of dust cap (D) Fig. 14, over the
opening on intake port. Press recessed side of
dust cap (D) into port opening. IMPORTANT: When
connecting an intake hose to one or both intake
ports, dO NOT REMOVE THE dUST CAP COLLARS
(F) FIg. 14 FROM THE INTAKE PORTS. Pull the dust
cap from the port opening and slide the collar and
cap farther onto the port housing.
ASSEMBLINg FILTER ANd dUST
COLLECTION BAgS TO dRUM
disconnect the machine from the power
source!
1. Hook the loop on the top of filter bag (A) Fig. 15,
onto filter bag support rod (B) as shown.
2. Assemble extension rod (C) Fig. 16, onto the end
of filter bag support rod (B). Raise support rods (B)
and (C), with filter bag (A) attached and place end
of support rod (C) into holes of bracket (D). NOTE:
Flared end of filter bag extension rod will prevent the
rod from sliding through bracket.
3. Position open end of filter bag (A) Fig. 16, over lip of
dust drum (E). Insert locking band (F) Fig. 17, through
the loops of filter bag (A) and fasten with clamp (G)
as shown in Fig. 18. NOTE: Make certain locking
band is positioned in the channel of drum (E) before
fastening clamp.
Fig. 16
B
C
A
D
E
10 -
English
Fig. 13
B
A
Fig. 14
F
A
Fig. 15
Fig. 17
A
G
E
E
D
E
D
B
F