Product-Dependent Symbols; Product Information; Declaration Of Conformity; Sticker On The Product - Hilti PM 2-PE Manual De Instrucciones

1.2.3 Symbols in the illustrations
The following symbols are used in illustrations:
These numbers refer to the corresponding illustrations found at the beginning of these operating
instructions
The numbering reflects the sequence of operations shown in the illustrations and may deviate
from the steps described in the text
Item reference numbers are used in the overview illustrations and refer to the numbers used in
the product overview section
This symbol is intended to draw special attention to certain points when handling the product.
1.3

Product-dependent symbols

1.3.1 Symbols on the product
The following symbols can be used on the product:
The power tool supports near-field communication (NFC) technology, which is compatible with
iOS and Android platforms.
1.4

Product information

products are designed for professional users and only trained, authorized personnel are
permitted to operate, service and maintain the products. This personnel must be specifically informed about
the possible hazards. The product and its ancillary equipment can present hazards if used incorrectly by
untrained personnel or if used not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Type
Generation
Serial no.
1.5

Declaration of conformity

We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistrasse 6 | D-86916 Kaufering, Germany
1.6

Sticker on the product

Laser information
Laser class 2 based on standard IEC60825-1 / EN60825-1:2014 and compliant with CFR
21 § 1040.10 and 1040.11 (Laser Notice 56).
Do not look straight into the laser beam.
2 Safety
2.1

General safety rules

▶ Check the accuracy of the tool before using it for measurements and applications.
▶ The tool and its ancillary equipment can present hazards when used incorrectly by untrained personnel
or when used not as directed.
▶ To reduce the risk of injury, use only genuine Hilti accessories and ancillary equipment.
▶ Stay alert, watch what you are doing and use common sense when operating the tool. Do not use the
tool while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention
while operating the tool may result in serious personal injury.
10 English
PM 2-PE
02
2288653
*2288653*