Velleman HAMGSM133 Manual Del Usuario página 12

Invert the condition of a relay for a certain time
Command: OUTx:ss
Example: OUT1:10
Deactivate (when already active) or activate (when deactivated) output relay 1 for the
next 10 seconds.
Request condition of outputs
Command: STA?
Example: STA?
Get an overview of the condition of the output relays.
Store and restore relay status after power cut
Command: RIPx
Example: RIP1
Relay statuses are automatically stored when a power outage occurs and restored when
power is restored.
Default: 1 (enabled)
Request current setting of relay status backup
Command: RIP?
Example: RIP?
Get an overview of the current setting for the output relay backup.
Start-up SMS content
Command: TSU:xxxxxxxx
Example: TSU: SYSTEM START-UP
When enabled (see AVVx command), this message is send to phone number on the first
position in the list.
Default: SYSTEM STARTUP
Note: a semi colon (;) is not allowed inside the message
Activate start-up SMS
Command: AVVx
Example: AVV1
Enable sending an SMS to the phone number on the first position in the list when the
device is (re-)started.
Default: 0 (disabled)
Gate control activation (relay 1)
Command: TAC:ss
Example: TAC:12
When receiving a call from any of the 200 gate control numbers or 8 numbers in the
master list, the relay will remain activated for 12 seconds.
Default: 3 seconds
Note: when setting the time to 00, the relay operates in bi-stable mode; relay 1 will
switch status every time the device receives a call.
Store gate control phone numbers (max. 200)
Command: MAC+YYnnnnnnnnnn;pwd
YY= country code
nnnnnnnnnn = phone number (max. 19 digits)
pwd = current password (default = 12345)
Example: MAC+324851234567;12345
Note: there are no specific locations for gate control phone numbers.
15/12/2011
x = 1 (output 1) or 2 (output 2)
ss = time in seconds (00~59)
x = 0 (disabled) or 1 (enabled)
xxxxxxxx = message (max. 100 characters, all capitals)
x = 0 (disabled) or 1 (enabled)
ss = time in seconds (00~59)
HAMGSM133
(password required)
12
© Velleman nv