Cleaning And Maintenance - Tunturi R50W Manual Del Usuario

Ocultar thumbs Ver también para R50W:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 59
English
Stop
Stop is displayed when there is no activity
registration for more than 2 seconds.
Console shuts in a Pause mode, and shows
"STOP".
Resume the training within 4 minutes to avoid the
console to shut in Stand By mode.
Explanation of buttons
Mode/ Reset
- Press Mode/ Reset button to select console
functions.
- Push and hold for 5 seconds in, stop Mode/
Reset, to reset: Time, Count, Distance &
Calories.
Opperation
Power on
- Press any key to power on the console when
being in sleep mode..
- Start pedalling to power on the console when
being in sleep mode.
Power off
Without any signal being transmitted into the
monitor for 4 minutes the monitor will enter
SLEEP mode automatically. ( Active training data
will be lost )

Cleaning and maintenance

The equipment does not require special
maintenance. The equipment does not require
recalibration when it is assembled, used and
serviced according to the instructions.
WARNING
Do not use solvents to clean the equipment.
Clean the equipment with a soft, absorbent
cloth after each use.
Regularly check that all screws and nuts
are tight.
If necessary, lubricate the joints.
CAUTION
Avoid dirt on the seatroller track. Dirt can
cause roller track damage, resulting in
quality issues.
16
Water changes colour or becomes
cloudy
Possible cause:
Rower is in direct sunlight or has not had water
treatment.
Solution:
- Change rower location to reduce direct
exposure to sunlight.
- Add water treatment or change tank water as
directed in the water treatment section of this
manual.
Replacing the batteries (fig. E-2)
The console is equipped with 2 AA batteries at
the rear of the console.
- Remove the console.
Press latch on bottom to release.
No need to disconnect the wire connection.
- Remove the old batteries.
- Insert the new batteries. Make sure that
batteries match the (+) and (-) polarity markings.
- Mount console back in position.
Ensure the latch on bottom is secured.
Troubleshooting
Despite continuous quality control, defects and
malfunctions caused by individual components
may occur in the equipment. In most cases it's
unnecessary to take the whole device in for repair,
as it's usually sufficient to replace the defective
part.
If the equipment does not function properly
during use, contact your Tunturi dealer
immediately. Always give the model and serial
number of your equipment. Please state also
the nature of the problem, conditions of use and
purchase date.
If you require spare parts, always give the model,
serial number of your equipment and the spare
part number for the part you need. The spare part
list is at the back of this manual. Use only spare
parts mentioned in the spare part list.

Publicidad

Tabla de contenido
loading

Tabla de contenido