Adjusting Blades And Counter Blades - TRAPP ES-500 Manual De Instrucciones

www.trapp.com.br
Sharpen each blade, trying to keep the original

cutting inclination. Whenever sharpening, be careful
to always remove the same amount of material from
each blade not to impair rotor balance which may
cause vibration.
Reassemble blades on rotor.

Reassemble all the blades on rotor, following the

tightening torque recommended in the torque table.
Image
merely B C
illustrative
Figure 14
Danger!
When assembling the blades, secure them

with their respective screws. After assembling,
carefully check if all screws are duly tightened
and if the distance between the blade and the
counter blade is correct before turning the
shredder on.
Blades must be replaced whenever they

cannot be perfectly sharpened anymore or if
damaged.

Adjusting blades and counter blades

The distance between the blade and the counter
blade is vital for proper functioning of the shredder.
The recommended distance between them is
approximately 1.5 mm.
To adjust the counter blade, follow the directions
according to Figure 15:
Loosen the blade support securing screws (B) and

decrease or increase the distance between the blade
and the counter blade, as required.
Displace the support with the blade so that you have

1.5 mm between the blade and the counter blade.
Retighten all blade support screws.

Repeat the operation with each blade.

Image merely
illustrative
A
Figure 15
Disassemble pin (C), as well as springs (A) and (B).

Hold the pin (C), lift the cover and move the toothed

cylinder forward.
Remove the 2 screws that secure the counter

blade (D).
Replace the counter blade.

Put the toothed cylinder back into the operation

position.
Do not forget to reposition the parts of the toothed

cylinder driving cardan.
Reposition the 2 springs.

Image merely
illustrative
Figure 16
B
A B C
55