Adjustments & Maintenance - Allett Liberty Classic 30 cm Instrucciones De Funcionamiento

F016J11384-A
Adjustments & Maintenance
STOP - Remove the isolator key and the batteries before making any adjustments
and wear gloves if you are working near the blades.
Note: To ensure long and reliable service, carry out the following maintenance regularly.
Regularly check for obvious defects such as a loose, dislodged or damaged blade, loose
fixings, and worn or damaged components. Check that covers and guards are undamaged
and correctly fitted. Carry out necessary maintenance or repairs before using. Clean the
exterior of the machine thoroughly
using a soft brush and cloth. Do not use water, solvents or polishes. Remove all debris,
especially from around the motor . If the mower should happen to fail despite the care taken
in manufacture and testing, repair should be carried out by an Approved service agent.
Speed adjustment
Please refer to illustration (K).
Adjust the speed as required by moving the speed control knob (4) between 1 (min) and 6
(max.). The speed control knob adjusts both forward travel and cutting cylinder speed.
If the grass is moist and heavy or if you are scarifying, a high cylinder speed is
recommended to improve collection performance. Set the speed adjustment knob to position
5-6.
If the grass is dry and light, a lower cylinder speed is recommended to improve collection
performance. Set the speed adjustment knob to position 3-4.
Height of cut adjustment – Liberty 30 & 35
Please refer to illustration (L)
Your machine has six settings which give the following approximate height of cut:
5 4 3
mm 32 25 19
1¼ 1 ¾
inch
Position "S" should only be used with the scarifier cartridge accessory (purchased
separately).
To adjust the height of cut:
1. Tilt the mower to take the weight off the front roller.
2. Push the height of cut knob (7) in and turn to the desired position.
For the first cut of the season, the highest cutting adjustment number 5 should be selected.
Height of cut adjustment – Liberty 43
Please refer to illustration (M)
Your mower has an infinitely adjustable height of cut between 6 - 32 mm, a numbered dial
on the side of the mower can be used as a guide to adjustment.
4 3 2
mm 32 25 19
1¼ 1 ¾
inch
A fifth position labelled "S" should only be used with the scarifier cartridge accessory
(purchased separately) or to achieve a particularly short cut if the lawn is very flat. The
height of cut is adjusted by turning the knob (7) at the right hand rear of the machine.
The comb will also require adjustment, see "Comb Adjustment".
Original instructions
2 1 S
13 9 6.5
½ 3/8 ¼
1 S
13 6.5
½ ¼
15