Using Extension Cords; Tools - Hilti TE 1 Manual De Instrucciones

Forward / reverse switch
2.4 Grips
Pivotable side handle with depth gauge
Vibration-absorbing grip
2.5 Protective feature
en
Mechanical slip clutch
2.6 Lubrication
Grease lubrication
2.7 Items supplied as standard
1 Power tool
1 Operating instructions
1 Hilti cardboard box or toolbox

2.8 Using extension cords

Use only extension cords of a type approved for the application and with conductors of adequate cross section. The
power tool may otherwise loose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 110-127 V
Mains voltage 220-240 V
Do not use extension cords with 1.25 mm² conductor cross section.
2.9 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.10 Using a generator or transformer
This power tool may be powered by a generator or transformer which fulfills the following conditions: The unit must
provide a power output in watts of at least twice the value printed on the type identification plate on the power tool.
The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in the 50
– 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and starting
boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.

3 Tools

Designation
Hammer drill bits, short
Hammer drill bits, long
14
1.5 mm²
30 m
75 m
Description
∅ 4...18 mm, Hammer drilling in concrete, masonry and
natural stone
∅ 4...18 mm, Hammer drilling in concrete, masonry and
natural stone
2.5 mm²
50 m
100 m
3.5 mm²