Bosch GPLL5 Instrucciones De Funcionamiento página 11

Switching On and Off
To switch on the tool, press the On/Off button 15. Immediately
after switching on, the tool sends a laser beam out of the exit
opening 9.
• Do not point the laser beam at persons or animals and
do not look into the laser beam yourself, not even from a
large distance.
To switch off the tool, press the On/Off button 15 again.
• Do not leave the switched on tool unattendedand switch
the tool off after use. Other persons could be blinded by the
laser beam.
Leveling Functions
Note: The specified leveling accuracy applies for the alignment
of the laser beam with reference to the spirit levels 6 and 7.
Positioning the Tool (see figure A)
For precise alignment with the spirit levels, the position of the
tool is important.
The specified leveling accuracy is only achieved when the tool is
correctly positioned:
• For horizontal alignment with the spirit level 7, the aluminium
supporting surface 8 of the tool must face downward.
• For vertical alignment with the spirit level 6, the exit opening
for the laser beam 9 must face upward.
Aligning with the Laser Line
Horizontal Alignment (see figures B and C): Position the tool
with the three supporting points 12 against the wall or with help
of the magnets 14, fasten it to the wall holder 1 or to another
magnetic surface. The aluminium supporting surface 8 of the
tool must face downward. Align the tool horizontally with help of
the spirit level 7. Picture frames or tiles, as an example, can be
aligned alongside the horizontal laser line.
Vertical Alignment (see figure C): Position the tool with the
three supporting points 12 against the wall or with help of the
magnets 14, fasten it to the wall holder 1 or to another magnetic
surface. The exit opening for the laser beam 9 must face
upward. Align the tool vertically with help of the spirit level 6. Top
and bottom cabinets, as an example, can be aligned alongside
the vertical laser line.
Alignment off of Reference Points (see figure D): Position the
tool with the three supporting points 12 against the wall or with
help of the magnets 14, fasten it to the wall holder 1 or to
another magnetic surface. Turn the tool to any angle in order to
-11-