Electrical Requirement - CORBERO CC1775W Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

refrigerator-freezer and the wall, and 300mm space between counter top and the
roof or ceiling.
If you are installing your refrigerator-freezer next to a fixed wall, leave sufficient
space on the hinge side to allow for the door to swing open.
Never install your refrigerator-freezer near heat source and direct sun shins.

ELECTRICAL REQUIREMENT

WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or electrical shock.
Before you move your refrigerator-freezer into its final location, it is important to
make sure you have the proper electrical connection.
RECOMMENDED EARTHING METHOD
AC220-240Volt /50Hz ,AC only 10 ampere fused and properly earthed electrical
supply is required. It is recommended that a separate circuit serving only this
appliance be provided. Use a receptacle which cannot be turned off with a switch
or pull chain. Do not use an extension cord.
NOTE:
Before
refrigerator-freezer from the electrical source. When you are finished, connect the
refrigerator-freezer to the electrical source and reset the control to the desired
setting.
performing
any
type
of
installation,
5
disconnect
the

Publicidad

Tabla de contenido
loading

Tabla de contenido