Wolf Garten Ambition Robo Scooter 300 Instrucciones De Servicio página 59

Ocultar thumbs Ver también para Ambition Robo Scooter 300:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 175
4.2.1 Starting Point: Perimeter Wire at the Base Station area.
• Place the Base Station, according to your plan, as shown in the
figure to the right.
• Do not place the Base Station within 3m (10 ft.) of a corner
• Select the roll of wire with a green plot connector attached to the
end.
• Pull the plot connector and some wire out of the plastic covering.
!
Do
not
remove
The
plastic
covering
Peg the beginning of the wire to the ground, where the Base Station
will be located. Pegs are supplied in the unit's box.
Pull out 30 cm (12 inches) of wire and leave it loose near the Base
Station location. Later, at the end of the setup, this part of the wire
will close the Perimeter Wire loop.
Start laying the wire in an anticlockwise direction.
Continue to pull the Perimeter Wire out of its covering, laying it
loosely as you walk along the lawn edge.
! If you get to any area /object that needs care or special boundaries, make sure you carefully lay the Perimeter
4.2.2 Laying the Perimeter Wire
o
The Perimeter Wire is secured to the ground by pegs
supplied with the unit. Initially insert pegs every few meters
and at corners. At this early stage set a minimum number of
pegs. Later, after testing the wire setup, you will insert all
necessary pegs.
o
After uncoiling some wire, before inserting pegs, use the
RoboRuler
to determine the distance of the wire from the
lawn edge or obstacles.
• If the working area borders against a flat area, flower
bed, small step (more than 1 cm), or a small elevation
(up to 5 cm), the Perimeter Wire should be laid 20 cm
(8 inches) inside the working area. This prevents the
wheels from driving into a ditch.
If the edge is sloped (max 10% is allowed) or is
bordered with high obstacles such as a wall or fence, the
Perimeter Wire should be laid at a distance of 28 cm (11
inches) from the obstacle.
en
the
spool
of
wire
from
is
the
dispenser
Wire as needed. The next sections deal with such special cases.
its
covering.
for
the
wire.
59

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ambition robo scooter 400Ambition robo scooter 600

Tabla de contenido