Using The Dc Kit - Waeco DC-Kit2 Instrucciones De Montaje

DC-Kit2
8

Using the DC kit

The DC-Kit2 consists of several components, each with its own installation
and operating manual. Use the installation and operating manuals for the
components and make sure you are familiar with the individual devices.
This chapter contains information on operating the overall system. This oper-
ating manual does not replace any information contained in the installation
and operating instructions for the components.
A
NOTICE!
CA2500, B2200, B1600 Plus, FJ1100, FJ1700, FJ2200,
FL1600, FL2200: the inverter may be damaged.
Ensure that these models are not used in the automatic air con-
ditioning mode or heating modes for driving. The inverter is not
designed for generating this amount of power.
A
NOTICE!
CA2500, B2200, B1600 Plus, FJ1100, FJ1700, FJ2200,
FL1600, FL2200: the inverter may be damaged.
If you are operating the system on the 230 V mains and the auto-
matic air conditioner or the heating is on, make sure that the
inverter is switched off and stays switched off.
The inverter is not designed for the amount of power an active
heating system requires. If the 230 V mains power fails, the
inverter would then take over supplying the power.
I
NOTE
The operating noises made by the roof air conditioner are slightly
louder during mobile air conditioning than during stationary air
conditioning. The noises are caused by using the inverter.
EN
Using the DC kit
37