Cleaning, Care & Maintenance; Replacing The Interior Lamp; Cleaning The Condenser - saro LISETTE Serie Instrucciones De Funcionamiento

CLEANING, CARE & MAINTENANCE
1 Switch off and disconnect from the power supply before cleaning
2 The doors can be removed for ease of cleaning
3 Clean the interior of the appliance as often as possible
4 Do not use abrasive cleaning agents These can leave harmful residues
5 Clean the door seal with water only
6 Always wipe dry after cleaning
7 Do not allow water used in cleaning to run through the drain hole into the evaporation pan

REPLACING THE INTERIOR LAMP

Call your dealer or a qualified electrician, the Lamp Assembly is available to purchase as a spare part

CLEANING THE CONDENSER

Periodic cleaning of the Condenser can extend the life of the appliance, recommend that a agent
TROUBLE SHOOTING
If your appliance develops a fault, please check the following table before making a call to the helpline
FAULT
The appliance is not working
The appliance turns on, but
the temperature is too high/
low
The appliance is leaking
water
The appliance is unusually
loud
The display lamp does not
illuminate
Door does not shut
6
PROBABLE CAUSE
The unit is not switched on
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
Too much ice on the condenser
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a heat source,
in the direct sunlight or air flow to the
condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being stored in
the appliance
Appliance is overloaded
Factory default parameters adjusted
The appliance is not properly
levelled
Loose screw/nut
The appliance has not been
installed in a level or stable
position
Lamp needs replacing
Light not turned On
Dirt/obstacle in runners
Stand V11/2017 O/IH/SA V12 10/2018 TM
ACTION REQUIRED
Check the unit is plugged in correctly and
switched on
Call or qualified technician
Replace the fuse
Check power supply
Call or qualified technician
Defrost the appliance
Call or qualified technician
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to fan
Reduce the amount of food stored in the
appliance
Call or qualified technician
Adjust the screw feet to level the appliance
(if applicable)
Check and tighten all nuts and screws
Check installation position and change
if necessary
Call or qualified technician
Ensure Light button has been pressed
properly
Clean runners
UK