Dremel 9100 Instrucciones De Funcionamiento página 10

DM 2610Z04970 10-13_9100 10/9/13 7:52 AM Page 10
Do not plug the motor unit
W RNING
directly into wall outlet.
Always plug the motor unit into the output
MOUNTING THE MOTOR UNIT
1. To mount the motor unit, start by securely
fastening the mounting bracket to a wooden
structure with two(2) #8x1.5" wood screws.
2. Hang the motor unit on the bracket by
placing the tool hanger in the hook on the
mounting bracket.
DO
W RNING
MOUNTING BRACKET TO
DRYWALL OR PEGBOARD. Mounting area
not strong enough to support the motor unit
leading to personal injury or property damage.
INSTALLING AND REMOVING
ACCESSORIES FROM HAND PIECE
WITH 3 JAW CHUCK
(Not included in all kits)
1 Unplug tool from power source.
2. To install an accessory, open the 3 jaw chuck
as far as necessary by rotating the chuck key
counter clockwise.
3. Insert the accessory fully into the chuck to
minimize runout and unbalance.
4. Turn the chuck key clockwise to tighten the
jaws and secure and center the accessory.
5. If the accessory does not run true, reopen
the jaws, rotate the accessory ¼ turn and
retighten.
FIG. 5
NOT ATTACH
10
connector of the Variable Speed Foot Pedal.
Operating accessory beyond its speed rating
will cause severe injury.
FIG. 6
6. To remove an accessory, simply open the
jaws by turning the key counterclockwise and
pull out accessory.
FIG. 7
3x