Dremel 9100 Instrucciones De Funcionamiento página 9

DM 2610Z04970 10-13_9100 10/9/13 7:52 AM Page 9
W RNING
W RNING
INSTALLING FLExIBLE SHAFT
TO MOTOR UNIT
1. To install flexible shaft to motor unit, remove
hand piece by firmly pulling from flexible shaft
2. Loosen set screw on Inner Shaft Collar with
hex key provided.
3. Align set screw to flat on Motor Output Shaft
and push Inner Shaft Collar fully on.
FIG. 4
CONNECTING MOTOR UNIT AND
VARIABLE SPEED FOOT PEDAL
1. To connect Motor Unit to power, with On/Off
switch in off position and foot pedal
unplugged, plug power cord from motor unit
into variable speed pedal.
Assembly
H ND PIECE
4. Tighten set screw to secure Inner Shaft Collar
to Motor Output Shaft.
5. Tighten Locking Collar by rotating it counter
clockwise until it is snug against the motor
housing.
2. With On/Off switch in off position and foot
pedal in free position, plug variable speed foot
pedal into wall outlet.
9
FIG. 3
SH FT
CLICK