Appliance Description; Before Initial Use; Wall Installation - essentiel b EAM 91 VIVARIO Instrucciones De Uso

Appliance description

5 6
10
11
1.
Dust container
2.
Dust container lid open button
3.
Indicator light
4.
On/Off switch
5.
Dusting brush
6.
Upholstery tool
7.
Crevice tool
8.
Charging and accessory stowage base
9.
Mains adapter
10.
F5 fi ne particle fi lter
11.
Pre-fi lter
20
V.7.0
your product
7
1
9
2
4
8

before initial use

Wall installation

The charger base can either sit on a fl at surface (Fig. 1) or be mounted vertically against a wall (Fig. 2).
3
To mount the charger base on a wall:
1.
Find a suitable location within 160 cm of an electric socket. If the base is less than 180 cm away,
make a coil with the excess wire behind the base and pass the power supply cord through the
cable entry.
Comment: Do not use an electric socket that is controlled by a switch.
2.
Place the base against the wall in the desired location and use a pencil to mark the centre of each
hole, taking care to ensure they are properly aligned. The distance between the holes is 12 cm.
3.
Drill a hole in the centre of the fi rst mark. Put a wall plug in the hole, then insert a screw and leave
the screw head slightly proud.
4.
Drill the second hole and fi t the second wall plug and screw.
5.
Tighten the 2 screws to secure the base to the wall.
Recharge the vacuum cleaner
The battery must be charged for 10 hours before the appliance is used for the fi rst time.
Comments:
•
The appliance will get warm when charging and in use. This is normal.
•
As your appliance is fi tted with a battery that does not suffer from the 'memory effect', you can
recharge it without having to discharge it fi rst.
Figure 1 Figure 2
21
V.7.0
before initial use