Operation Procedures; To Stop Engine - Dolmar PM-4810 Manual De Instrucciones

2. (for PM-4810)
When starting cool, press the primer bulb (18) 3 – 5
times before starting the engine, turn throttle choke
lever to " " position.
When starting warm engine and operating, turn throttle
" position. (Fig. 8A & 8B)
choke lever to "
3. Standing behind the unit grasp the brake control
handle and hold it against the upper handle as shown
in Fig. 8C.
4. Grasp the starter handle as shown Fig. 8C and pull
up rapidly. Return it slowly to the rope guide bolt after
engine starts.
Release the brake control handle to stop the engine and
blade. (Fig. 8D)
Start the engine
instructions and with feet well away from the
blade.
Do not tilt the lawn mower when starting the
engine. Start the mower on a level surface, free
of high grass or obstacles.
Keep hands and feet away from the rotating
parts. Do not start the engine when standing in
front of the discharge opening.

10.3 OPERATION PROCEDURES

During operation, tightly hold the brake handle with both
hands.
NOTE:
• During operation, when the brake handle is released,
the engine will stop and thus stopping the lawn mower
from operating.
WARNING:
• In order to avoid any unintentional start-ups of the lawn
mower, it comes equipped with an engine brake which
must be pulled back before the engine can be started.
When the engine control lever is released it must
return to its initial position, at which point the engine
automatically switches off.
NOTE:
• Engine brake (brake handle): Use the lever to stop the
engine. When you release the lever the engine and
the blade stop automatically. To mow, hold the lever in
the working position. Before you start to mow, check
the start/stop lever several times to be sure that it is
working properly. Ensure that the tension cable can
be smoothly operated (i.e. is not catching or kinking
in any way).

10.4 TO STOP ENGINE

CAUTION:
• The blade continues to rotate for a few seconds after
the engine is shut off.
1. Release the brake control handle to stop the engine
and blade.
carefully according to
2. Disconnect and ground the spark plug wire as
instructed in the separate engine manual to prevent
accidental starting while equipment is unattended.
10.5 CONNECTION FOR AUTO MOVE
For PM-4820 S
Grip the self-drive control handle, the lawn mower will
move forward automatically with about 3.6 km/h (Fig. 9),
release the self-drive handle, the lawn mower will stop
move.
CAUTION:
• Your mower is designed to cut normal residential grass
of a height no more than 250 mm.
Do not attempt to mow through unusually tall dry or wet
grass (e.g., pasture) or piles of dry leaves. Debris may
build up on the mower deck or contact the engine exhaust
presenting a potential fire hazard.
10.6 FOR THE BEST RESULTS WHEN
MOWING
Clear lawn of debris. Be sure that the lawn is clear of
stones, sticks, wire or other foreign objects which could
be accidentally thrown out by the mower in any direction
and cause serious personal injury to the operator and
others as well as damage to property and surrounding
objects. Do not cut wet grass. For effective mowing
do not cut wet grass because it tends to stick to the
underside of the deck preventing proper mowing of the
grass clippings. Cut no more than 1/3 the length of the
grass. The recommended cut for mowing is 1/3 the length
of the grass. Ground speed will need to be adjusted so
the clippings can be dispersed evenly into the lawn.
For especially heavy cutting in thick grass it may be
necessary to use one of the slowest speeds in order to
get a clean well mowed cut. When mowing long grass
you may have to cut the lawn in two passes, lowering the
blade another 1/3 of the length for the second cut and
perhaps cutting in a different pattern than was used the
first time. Overlapping the cut a little on each pass will
also help to clean up any stray clippings left on the lawn.
The mower should always be operated at full throttle
to get the best cut and allow it to do the most effective
job of mowing. Clean underside of deck. Be certain to
clean the underside of the cutting deck after each use
to avoid a build-up of grass, which would prevent proper
mulching. Mowing leaves. The mowing of leaves can also
be beneficial to your lawn. When mowing leaves make
sure they are dry and are not laying too thick on the lawn.
Do not wait for all the leaves to be off the trees before
you mow.
WARNING:
• If you strike a foreign object, stop the engine. Remove
wire from spark plug, thoroughly inspect the mower for
any damage and repair the damage before restarting
and operating the mower. Extensive vibration of the
mower during operation is an indication of damage.
The unit should be promptly inspected and repaired.
13