Machine Warnings (Mod. C); Warning Display; Recycling The Product - Fagor evo Serie Instrucciones De Instalación, Uso Y Mantenimiento

EN
E10
Rinse error
E11
Max tank level error
E12
Min. tank level error

6.3 Machine warnings (MOD. C)

WARNING DISPLAY
A1
A1-Door open
A2-Change
A2
water
A3-Low wash
A3
temperature
A4- Low rinse
A4
temperature
A5-SALT (only
A5 in SOFT
models)

7. RECYCLING THE PRODUCT

The WEEE symbol used for this product indicates that it cannot be treated as domestic waste. Disposing
correctly of the product will help to protect the environment. For further information about the recycling of
these products, please contact the relevant office in your local authority, or the company responsible for
waste disposal or the manufacturer who supplied this product.
To dispose of all or part of the product, directives 2002/95/EC and 2002/96/EC and
successive amendments and/or applicable legislative decrees must be observed. The
manufacturer guarantees the absence of hazardous substances in the EEE used complaint
to directive 2002/95/CE.
In the event of failure to comply with the above, the user will be subject to the penalties
established by each of the member countries of the community.
Cut the electric cable so that it is unusable. Only those plastic parts bearing the recycle
symbol can be recycled.
48
If PC>20 the level does not go
down 5 mm in 12 seconds.
PT4 tank level has been
reached (To reject interference,
the level must be detected for at
least 2 seconds).
PT1 tank level has been
reached while in standby (To
reject interference, the level
must be detected for at least 2
seconds).
CAUSE
Door open when new cycle starts.
Concentration of detergent and dirt in
tub too high. This warning is given after
1
100 wash cycles without draining the
machine. If PT=0, the number of cycles
is automatically reset.
TT 10 ⁰C below programmed wash
temp. When a wash cycle is run with a
tank temperature lower than the
programmed temperature.
TC 10 ⁰C below programmed rinse
temp. When a rinse cycle is run (8 min of
thermo-stop completed) with a boiler
temperature lower than the programmed
temperature.
SALT level in regeneration not detected.
1
The number of cycles is configurable.
MESSAGE: "E10-INCORRECT
RINSE". The machine is not disabled.
The error is displayed and an acoustic
signal is emitted for 30 seconds every 3
minutes, for 15 minutes.
MESSAGE: "E11-MAX. TANK LEVEL"
and an acoustic signal for 30 seconds
every 3 minutes, for 15 minutes.
Machine completely disabled The
machine drains until level PT3 is
reached.
MESSAGE: "E11-MIN. TANK LEVEL"
and an acoustic signal for 30 seconds
every 3 minutes, for 15 minutes.
Machine completely disabled.
METHOD OF WARNING
Warning flashes on
display for 5 seconds.
Warning flashes on
display for 5 seconds
every time a cycle ends.
Warning flashes on the
display until the
programme ends,
alternating with the
normal screen message.
Warning flashes on the
display until the
programme ends,
alternating with the
normal screen message.
Warning flashes on the
display until the
programme ends,
alternating with the
normal screen message.
CORRECTIVE
ACTION
Close the door.
Draining the
machine.
The current
cycle ends.
The current
cycle ends.
Insert salt in
corresponding
deposit.