Start-Up; To Attach Spent Mandrel Container; To Set A Blind Rivet - Gesipa AccuBird Instrucciones De Manejo

GB
BULB-TITE Ø (mm)
®
4
5.2
6.3
BULB-TITE Ø
®
(mm)
6.3
* available as special accessory. Elongated nosepieces and other special nosepieces are
available on request.
** also available as conversion kit Part No. 143 5033.
1.7

Start-Up

Before starting the riveting tool, read and observe the operating instructions and safety
information and keep in a safe place.
• Insert fully charged battery in correct position into riveting tool.
• Select nosepiece from Table 1.6 and screw on (17/32 in working position).
Caution!
The air inlets for the motor should not be obstructed; do not insert any objects
into them.

1.7.1 To attach spent mandrel container

• Fully screw on spent mandrel container (No. 31) by turning clockwise.

1.7.2 To set a blind rivet

a. Pressing and holding the switch:
Press and hold the switch to start riveting. The pulling process stops automatically when the
rivet reaches the rear end position. The tool automatically assumes the front starting position
when the switch is released.
b. Tapping the switch:
Riveting is triggered by briefly tapping and immediately releasing the switch. As soon as the
mandrel breaks off, the blind riveting tool stops and automatically re-assumes the front start-
ing position.
20
Rivet material
Al/Al
Al/Al
Al/Al, steel/steel
Rivet material Jaw pusher
Al/Al, steel/steel
Nosepiece
17/26 BT*
17/32 BT*
17/42 BT**
Part No.
5** 143 4992
Part No.
143 4985
143 4986
143 4988
Jaws Part No.
4** 143 4173