Section 2 General Information And Setup; Know Your Power Washer; Emissions Information - Generac PRO 6712 Manual Del Operador

Section 2 General Information and Setup

A
S
P
Table 2-1. Power Washer Components
A Spray Gun
B Lance with Quick Connect
C High-Pressure Hose
D Recoil Starter
E Oil Fill
F Air Filter
G High-Pressure Pump
H Thermal Relief Valve
I Engine On/Off Switch
J Unloader Valve
K High-pressure Outlet
L Water Inlet
M Fuel Tank
N Fuel On/Off Valve
O Choke
P Belt Guard
R Nozzles
S Adjustable Side Handle
T Oil Drain Plug
U Serial Number Location.
Identification Label (not shown) – located
*
on engine blower housing
Detergent Siphoning Tube/Filter (not
*
shown)
Owner's Manual for Power Washer
C
B
M
F
E
Figure 2-1.Features and Controls
O
N
D
I
R

Know Your Power Washer

Consult Manual. Read and understand manual
completely before using product. Failure to
completely understand manual and product
could result in death or serious injury.
Read this
assembling and operating this unit. Save this
manual for future and immediate reference.
Replacement owner's manuals are available
at www.generac.com.

Emissions Information

The U.S. Environmental Protection Agency
(and California Air Resource Board for
equipment certified to CA standards) requires
that this engine comply with exhaust and
evaporative emission standards. Locate the
emissions compliance decal on the engine to
determine what standards the engine meets,
and to determine which emissions warranty
applies. The engine is certified to meet the
applicable emission standards on gasoline. It
is important to follow the maintenance
specifications in the Maintenance section to
verify that the engine complies with the
applicable emission standards for the duration
of the product's life. This engine utilizes lean
carburetion settings and other systems to
reduce emissions. Tampering with or altering
the emission control system may increase
emissions and may be a violation of Federal
or California
tampering include but are not limited to:
• Removal or alteration of any part of the
intake, fuel, or exhaust systems.
• Altering or defeating the governor linkage
or speed-adjusting mechanism to cause
the engine to operate outside its design
parameters.
U
G
K
L
U
T
WARNING
manual thoroughly
Law. Acts that
H
J
000264
(000100a)
before
constitute
3