Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: Read entire owner's manual before you
attempt to assemble or operate your new pressure washer.
REMOVE PRESSURE
WASHER FROM
CARTON
• Remove the parts box packed with pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat, then
remove all packing material.
• Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
• Main Unit
• Parts Box (which includes the following):
•
Safety Goggles
•
Handle
•
Plastic Accessory Tray
•
Handle Fastening Hardware Kit (which includes):
•
Carriage Bolts (2)
•
Plastic Knobs (2)
•
"J" Hook
•
Chemical Hose Clip
•
Self Tapping Screws (5)
•
Nozzle Cleaning Kit
•
High Pressure Hose
•
Owner's Manual
•
Engine Manual
•
Engine Warranty Card
•
Emissions Control Warranty Card
•
Owner's Registration Card
•
Spray Gun with Quick Connect Fitting
•
Nozzle Extension with Quick Connect Fitting
•
Bag containing 5 multi–colored Quick Connect Nozzles
•
Oil Bottle
•
O-Ring Maintenance Kit
If any of the above parts are missing or damaged, call the
pressure washer helpline at 1–800–270–1408.
Generac Portable Products 2,500 PSI High Pressure Washer
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged, call the
pressure washer helpline at 1-800-270-1408.
To prepare your pressure washer for operation, you
will need to perform these tasks:
• Fill out and send in registration card.
• Attach accessory tray to handle, then attach handle to
main unit.
• Add oil to engine crankcase.
• Add fuel to fuel tank.
• Connect high pressure hose to spray gun and pump.
• Connect water supply to pump.
• Attach nozzle extension to spray gun.
• Select/attach quick connect nozzle to nozzle extension.
Attach Handle and Accessory Tray
NOTE: All assembly operations given in this section will
be described from the perspective of assembling the
pressure washer from the rear.
• Slide the plastic accessory tray onto the handle and align
the holes in the accessory tray with the holes on the
handle (Figure 1).
Figure 1 — Attach Accessory Tray
5
Publicidad
Tabla de contenido
