Advanced Function - Gabarron RFE Plus Serie Instrucciones De Instalacion Y Uso

EN
WEEKLY PROGRAMMES
It is possible to allocate different programs to different days of the week. To do this, the controller has to be upgrade from
24hr mode (factory default) to 24hr/7days mode as follows:
Move the selector to
maintaining the key at least five seconds. The display will show
SETTING THE DAY: Press the
number, if required, by pressing
and new values will be stored.
To check a programme or to make a new one press
00:00
display will show
dia1
again . Repeat this process with the 7 days of the week. When the display shows
by pressing + key.
If the display shows
and so on.
It is possible to allocate any of the three temperature levels to all the intervals of any day maintaining the

relevant
To turn back a controller from 24hr/7days to a single 24hr press
default settings.
KEYBOARD LOCK

Press the key more than six seconds and the keyboard will be locked. The display will show
will keep on working internally. To unlock the keyboard, press again the
SUN MANUAL OVERRIDE
In programming mode, the heater will maintain the sun temperature set point and will ignore the pre-set program until the next
change in programming temperature level.
Maintain the SUN Key pressed for 4 seconds in programming mode to set the Sun Manual Override. Both luminous indicators
SUN and MOON will be lit. This function could be useful when SUN temperature is required and we do not want to modify the
program.
By pressing the SUN key for 4 seconds with Sun Manual Override activated, the function will be removed and the heater will
follow the programme again.

4.- ADVANCED FUNCTION

OPEN WINDOW DETECTION
With open window detection activated, the heating element will be disconnected automatically when a sharp decrease in
temperature in the room is detected avoiding energy wastage. After this period of time, the radiator returns to the prior
operation mode.
When Open Window Detection is working, the word Open will be displayed alternating with the status of the current mode.
Note: To activate the open window detection please refer to ADVANCED FUNCTION ACTIVATION section.
0
position, the display will be Off. Press the
key more than two seconds and the display will show the number of the day. Set the correct
+ –
or keys. Press the
intermittently. Follow now the steps from DAILY PROGRAMMES section until the display shows
dia1
then, pressing + key more than three seconds will copy the day 1 program to day 2
key until an audible signal is heard.
key and at the same time turn the selector to
P-SE
which means that weekly mode has been set.
key and the display will show now the time. Press again the
PRG
key: The display will show
PRG
key more than six seconds. This will restore the factory

key more than six seconds.
15
dia1 PRG
. Press again
dia7
the weekly program will be stored
and the controller
P
position
key
key and the