BLACK&DECKER Freewire FW3000 Manual De Instrucciones página 10

Step by step operating instructions for the OUTDOOR LAMP RECEIVER
A Quick Note before You Set Up the OUTDOOR LAMP RECEIVER:
The OUTDOOR LAMP RECEIVER can be used indoors and outdoors.
WARNING: When used outdoors, only use with outlets equipped with ground fault protection.
WARNING: Do not submerge. Keep connections dry. Failure to do this could result in electric shock.
WARNING: Read and understand warnings on your extension cord. Failure to do this could result in electric shock.
WARNING: To prevent shock hazard, always assume the power is present even if the red indicator light is not lit. Failure to do this
could result in electric shock.
WARNING: Do not abuse extension cord. Do not yank extension cord to disconnect it from receptacle. Keep cord from heat, oil and
sharp edges. Periodically inspect extension cords and replace if damaged. Failure to do this could result in electric shock.
Unlike LAMP and APPLIANCE RECEIVERS the OUTDOOR LAMP RECEIVER does not have any code wheels. You set its code up from the
MESSENGER HUB and it then remembers this code, even after a power outage. For ease of programming, initially place the OUTDOOR LAMP
RECEIVER in the same wall outlet that the MESSENGER HUB is plugged into. After programming you can move it to its final location.
Step 1:
Set the unit code on the INDOOR REMOTE to the color and number that you want to use to control the OUTDOOR LAMP RECEIVER in its
final location. (Example : Blue 11)
Step 2:
Plug the OUTDOOR LAMP RECEIVER into the same wall outlet as the MESSENGER HUB or you can move the
MESSENGER HUB and plug into the same wall outlet as the OUTDOOR LAMP RECEIVER. (The Messenger Hub will not
lose its memory and it can be moved back later.) See Figure 23. The red indicator light on the OUTDOOR LAMP
RECEIVER should now be on.
Within 30 seconds of plugging OUTDOOR LAMP RECEIVER in, press and hold for 5 seconds the on button on the
INDOOR REMOTE that corresponds to the UNIT CODE that you have selected. After a few seconds, the red indicator light
on the OUTDOOR LAMP RECEIVER will flash indicating that the code has been learned. If the switch in the OUTDOOR
LAMP RECEIVER is on, the red indicator light will remain lit. If the OUTDOOR LAMP RECEIVER switch is off, the red
indicator light will not be lit.
NOTE: If the red indicator light does not turn on in 5 seconds, unplug the OUTDOOR LAMP RECEIVER, re-plug and
repeat step 2. If indicator light still does not turn on, move the MESSENGER HUB and OUTDOOR LAMP RECEIVER to a
different outlet in a different room and repeat step 2.
Step 3:
You may now move the OUTDOOR LAMP RECEIVER to its final location.
CAUTION: For outdoor use with extension cords: Plug OUTDOOR LAMP RECEIVER directly into wall outlet, then plug "outdoor rated"
extension cord into OUTDOOR LAMP RECEIVER to reduce the risk of electric shock.
OUTDOOR LAMP RECEIVER NOTES:
1.) OUTDOOR LAMP RECEIVER can be used with incandescents, fluorescents, halogens and low voltage lights rated up to 500 watts.
2.) If outlet is controlled by a wall switch, you must leave wall switch on at all times otherwise the OUTDOOR LAMP RECEIVER will not
have AC power and you won't be able to control it remotely.
3.) To change the unit code, that the OUTDOOR LAMP RECEIVER responds to, unplug OUTDOOR LAMP RECEIVER and repeat
steps 1 through 3.
4.) Unplug OUTDOOR LAMP RECEIVER when not in use.
5.) Operating Temperatures -4°F to 122°F.
Storage Temperatures -40°F to 158° F.
10
23