Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step by step instruction to developing GROUP SETTINGS
A Quick Note before You Program the Mood Settings:
In the Lamp Receiver section you learned how to set up individual LAMP RECEIVERs. These LAMP RECEIVERs are turned on and off by
pressing the appropriate rocker switch that corresponds to the receivers unique UNIT CODE. The purpose of the GROUP buttons (blue) are to
link multiple receivers (up to 4) so that they can be turned on or off by the GROUP button. See Figure 16.
Example: If you have a LAMP RECEIVER in one room and it is set to the number 7 on its UNIT CODE and you have another LAMP RECEIVER
in another room and it is set up to the number 13 on its UNIT CODE, the two lamps can be turned on at the same time using a GROUP.
13
Step1:
With the MESSENGER HUB still plugged into an AC outlet, set the slide switch to LEARN as shown in Figure 15.
Step 2:
While facing the MESSENGER HUB, press GROUP 1 ON switch on the INDOOR REMOTE. Figure 16 -
The MESSENGER HUB's green indicator light will flash.
Step 3:
Set the UNIT CODE dial of the INDOOR REMOTE to match the UNIT CODE of the LAMP RECEIVER
that you want to turn on and off. Press on the rocker switch (white) corresponding to that LAMP
RECEIVER as shown in Figure 17. Wait for the MESSENGER HUB indicator to flash indicating the code
has been stored in the GROUP function.
Step 4:
Repeat step 3 a maximum of 3 more times to link up to 4 LAMP RECEIVERs / BULB RECEIVERs with
that GROUP key. The 4 LAMP RECEIVERs can be in any combination of UNIT CODES.
Step 5:
Return the slide switch on the MESSENGER HUB to RUN - Figure 18. The ON/OFF button of GROUP 1 will now turn
on and off all of the LAMP RECEIVERs / BULB RECEIVERs that were linked in Step 4. There may be up to a 3 second
delay between the time that you press the button and the time that the lights respond.
Step 6:
To set up GROUP 2 key, repeat steps 1 thru 5 substituting GROUP 2 key for GROUP 1.
NOTE: Pressing either GROUP ON key while in LEARN mode clears all stored codes for that GROUP.
Pressing the INDOOR REMOTE HOUSE BUTTON (figure 19) "on" will activate the MESSENGER HUB, LAMP RECEIVERs
and BULB RECEIVERs set to the system's HOUSE CODE. OUTDOOR LAMP RECEIVERs and APPLIANCE RECEIVERs will
not respond to the all "on" command. Pressing the INDOOR REMOTE HOUSE BUTTON "off" will deactivate the above
receivers as well as all OUTDOOR LAMP RECEIVERs and APPLIANCE RECEIVERs.
Unit Code Dial
House Code Dial
Run / Learn Slide Switch
Using ALL on, ALL off House Button
14
ON
ON
Rocker Switch
OFF
ON
Group Button
MOOD 1
OFF
9
OFF
ON
ON
OFF
OFF
ON
ON
MOOD 2
HOUSE
House Button
OFF
OFF
15
16
ON
ON
MOOD 1
MOOD 2
OFF
OFF
17
ON
ON
ON
Rocker Switch
18
19
HOUSE
ON
HOUSE
OFF
OFF
ON
ON
OFF
Publicidad
Tabla de contenido
