Mounting The Back Handle; Securing The Chimney; Installing The Lid Stopper; Mounting The Cabinet Door Handle, Door Latch - Pit Boss Pro PBV4PS1 Manual De Montaje

11. MOUNTING THE BACK HANDLE

Parts Required:
1 x Hopper Handle (#4)
4 x ¼–20x⅝" Screw (#C)
Installation:
• Mount the hopper handle onto the back side of the hopper using four
screws (#C) . Note correct position in illustration with handle on top.

12. SECURING THE CHIMNEY

Parts Required:
1 x Chimney Cap (#2)
Chimney Stack (#3)
1 x
#10–24x½" Screw ( #D)
4 x
Installation:
• Locate the chimney opening on the top of the main cabinet. From the
outside, secure the chimney to the top panel using four screws. The
screw will fasten to the self-clinching nut on the inside of the cabinet.
Next, twist the chimney cap onto the top of the chimney stack.
NOTE: Adjust the chimney cap to affect the airflow inside the main
grill. If cooking at low temperature, keep the cap more open.

13. INSTALLING THE LID STOPPER

Parts Required:
1 x Lid Stopper (#5)
#10–24x½" Screw ( #D)
2 x
Installation:
• Install the lid stopper onto the top of the main cabinet near the hopper
lid, using one screw on the top side and one screw on the inside edge
between the hopper lid hinges.

14. MOUNTING THE CABINET DOOR HANDLE, DOOR LATCH

Parts Required:
Cabinet Door Handle (#7)
1 x
1 x Cabinet Door Latch (#8)
4 x #10–24x½" Screw ( #D)
Installation:
• First, remount cabinet door to the main cabinet by aligning and
securing both hinges. Ensure the door is mounted correctly by testing
it opens freely. Note 14A.
• Mount the cabinet door handle onto the front side of the cabinet door
using two screws. Note correct direction in 14B.
• Mount the cabinet door latch onto the exterior side of the main
cabinet using two screws. Note 14C.
IMPORTANT: Fine tune and test the cabinet door latches and hooks
to ensure they align properly and there is a proper seal while the
10
11
4
C
12
D
2
3
13
D
5
14
14A
14C
7
D
14B
C
D
8
D