Additional Information; Troubleshooting - Aiwa HV-FX8100U Instrucciones De Manejo

ADDITIONAL INFORMATION

Troubleshooting

If the VCR does not seem to operate properly, read the
instructions again, then check the following guide.
The POWER button does not operate.
Make sure the AC cord is connected securely.
TV reception is noisy or there is no TV reception.
• Connect the VCR to the antenna and TV correctly and
securely.
• Move the VCR away from the TV set.
There is no sound.
Connect the VCR correctly and securely.
The playback picture is noisy.
• Make sure the TV is set to the video channel or video
input.
• Adjust the tracking manually when the tape quality is poor.
• Although the unit cleans the video heads automatically, dirt
may be accumulated after a long period of use. Clean the
video heads with a commercially available video head
cleaning tape.
• Make sure all the connections with the VCR are made
correctly and securely.
There is no playback picture.
Set the TV to the Video channel or video input.
Tape operation buttons do not work while the power is
on and the cassette is inserted.
Moisture condensation may have occurred. Wait for about
two hours until moisture evaporates completely before you
operate the unit.
Abnormal operation has occurred.
External interference may have affected the internal
microprocessor.
Wait for about five minutes after disconnecting the AC cord
from the AC outlet. Then connect it again, and press c
PLAY while holding down CHANNEL M on the VCR for
two seconds.
The timer does not operate.
• Set the clock correctly.
• Check that the channel numbers match the guide channels
which assigned to the TV stations.
There is no sound and picture from an input source.
Press INPUT to display "L" in the display window..
The remote control does not operate
• Replace both batteries with new ones.
• Make sure the VCR/CATV/TV selector on the remote is set
to VCR.
Clicking noise sounds.
Unavoidable expansion or contraction of cabinet due to
temperature changes. This is not a problem.
29
ENGLISH
Note on moisture condensation
Moisture may condense inside the unit and cause damage
to the unit and tape when the unit is moved from a cold to a
warm place, after heating a cold room, or under conditions of
high humidity. If any of the above conditions apply, place the
unit in a well-ventilated area and wait for about two hours
until the unit is warmed to room temperature and the
moisture evaporates completely before operating the unit.