HQ-Power VDPLP64 Serie Manual Del Usuario página 4

• Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty
and the dealer will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room
temperature.
• This device is designed for professional use on stage, in discos, theatres, etc. The VDPLP64xx
can be used indoor (<35°C, <75%RH) with an alternating current of max. 240V AC/50Hz.
• Lighting effects are not designed for permanent operation: regular operation breaks will prolong
their lives.
• Use the original packaging if the device is to be transported.
• Keep this manual for future reference.
4. Features
• fanless cooling
• short double bracket
• stand-alone, master/slave or music trigger mode
• DMX-controlled via 5 channels for smooth RGB colour mixing
• dimmer and shutter function via DMX mode
• special angled connection panel
• lens protection screen
• blue LED display for easy menu setup (auto-off function)
5. Overview
Refer to the illustrations on page 2 of this manual.
1 MODE selection button
2 UP-Button
3 DOWN-Button
4 LCD
6.
Installation
a) Floor standing
• Loosen the knobs on the side of the mounting bracket and unfold the bracket.
• Place the device in such a way that passers-by can not touch it nor stumble over it or its power
cord(s).
b) Overhead mounting
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
• The construction to which the device is attached should be able to support 10 times the weight of
the device for one hour without deformation.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by and inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in serious injuries.
• For truss-mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of
the (folded) bracket.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 50cm radius of the device.
20.04.2010
VDPLP64xx (xx = B2, C2, B3, C3)
5 DMX input
6 DMX output
7 AC output
8 AC input
4 ©Velleman nv