Dremel MultiPro 275T6 Manual De Uso página 16

DM 2610925474 10-04
Assembly & Operation of Attachments - (Cont.)
Operating Instructions
Always pull the tool toward you!
!
WARNING
Do not push it! Pushing the bit
may cause it to break. Hold the tool in a golf grip
with the tool positioned below the attachment and the
bit pointing upwards.
On your variable speed tool, recommended tool speed
is 15,000-20,000 RPM's or speed setting 6 to avoid
damage to the bit. On your two speed tool,
recommended tool speed is "Low" to avoid damage to
the bit. Do not force the bit or put pressure on the
back of the tool to remove the grout. Let the speed of
the rotating bit do the work.
Wear eye protection and dust
!
WARNING
mask. Inspect bit for damage.
When bit is installed, always run it at no-load speed
of the tool for one minute, as a damaged bit will
break apart. Do not stand in front of or in line with
bit.
Always use the tool with the depth guide positioned
flat against the material being cut.
The guide securely positioned on the material
improves stability and control of your tool.
The direction of feed with the bit into the grout is
important. Always drag or pull the bit through the
grout line. The grout bit is not intended for "plowing"
through the grout and feeding the tool in the wrong
direction will cause the bit to climb out of the work
possibly damaging the bit and/or causing loss of
control.
10/19/04 3:40 PM
Page 16
Page 16