Mitsubishi Electric PLK-E Serie Manual Básico página 138

M-015 [Message] FUNCTION PROHIBITION SETTING (DCC) OF PRESENT VALUE IS ON
M-016 [Message] VALUE IS EXCEEDING THE SET VALUE NOW
M-017 [Message] STOPPING AT DWON POSITION
M-018 [Message] THE SETTING TABLE NUMBER IS CHANGED
M-019 [Message] END CODE IN THIS SEWING DATA IS NOT FOUND
M-020 [Message] START INPUT SIGNAL IS ON
M-021 [Message] CLAMP INPUT SIGNAL IS ON
M-028 [Message] It is a termination
M-040 [Message] STEP SEQUENCE ILLEGAL SETTING DATA
M-041 [Message] STEP DATA NOTHING
M-042 [Message] S6 SIGNAL INPUT THEN MACHINE NOT START
M-043 [Message] START PROHIBIT SIGNAL INPUT THEN MACHINE NOT START
M-044 [Message] COUNT UP THEN MACHINE NOT START
M-050 [Message] PRESS HOME KEY
M-051 [Message] ILLEGAL SETTING
M-052 [Message] TOO LARGE SETTING VALUE
M-053 [Message] TOO SMALL SETTING VALUE
M-054 [Message] CAN NOT FIND DATA
M-055 *.The stitch number exceeds the preset No. of stitches.
[Message] TOO MANY STITCHES
M-056 [Message] OUT OF DATA NUMBER
M-057 *.A pattern that exceeds the area limit value has been read in.
[Message] OUT OF AREA LIMIT
[Sub Message] PLEASE TURN OFF SETTING (DCC) WHEN CORRECTING.
[Sub Message] PLEASE INPUT SMALL VALUE FROM SET VALUE TO PRESENT VALUE
NOW.
[Sub Message] NEEDLE BAR MOVES TO THE UP POSITION WITH NEEDLE RISE KEY.
[Sub Message] THE SET TABLE NUMBER IS SET IN THIS SEWING DATA
[Sub Message] PLEASE ADD END CODE IN INPUT MODE OR MODIFY MODE
[Sub Message] PLEASE TURN OFF START INPUT SIGNAL
[Sub Message] PLEASE TURN OFF CLAMP INPUT SIGNAL
[Sub Message] SEE YOU AGAIN!
[Sub Message] PLEASE CORRECT THE STEP SEQUENCE
[Sub Message] PLEASE MAKE THE STEP SEQUENCE
[Sub Message] PLEASE RELEASE THE S6 SIGNAL.
[Sub Message] PLEASE RELEASE THE START PROHIBIT INPUT SIGNAL.
[Sub Message] PLEASE CLEAR THE COUNTER.
[Sub Message] PLEASE INPUT A CORRECT VALUE
[Sub Message] PLEASE INPUT THE VALUE WITHIN THE RANGE
[Sub Message] PLEASE INPUT THE VALUE WITHIN THE RANGE
[Sub Message] THERE IS NO DATA
*.Decrease the No. of stitches or change [A] mode
[sewing data No. of divisions setting (FLB.)]
[Sub Message] PLEASE DECREASE THE NUMBER OF STITCH
[Sub Message] PLEASE DECREASE THE INPUT POINT
*.Change the following function setting accordingly. Change the [A] mode [sewing area limit
cancel (ALC.)] function to [ON] setting.
[Sub Message] PLEASE MAKE THE DATA IN THE AREA LIMIT
135